Factors influencing brightness and beam quality of conventional and distributed Bragg reflector tapered laser diodes in absence of self-heating
IET Optoelectron., vol. 8, no. 2, pp. 99-107 (2014).
Copyright © The Institution of Engineering and Technology. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the Institution of Engineering and Technology.
In this study, the authors examine some of the factors affecting the brightness and the beam quality of high-power tapered lasers. The large volume resonators required to achieve high-power, high-brightness operation make the beam quality sensitive to carrier lensing and multimode operation. These cause bleaching of the regions outside the ridge waveguide. The beam quality in the conventional and the distributed Bragg reflector tapered lasers is examined in the absence of the selfheating effects in order to investigate the impact of the carrier lensing effects. The influence of the front facet reflectivity and the taper angle on the beam quality is investigated. The beam quality was found to degrade with an increase in the front facet reflectivity and for larger taper angles in the conventional tapered lasers, especially at low ridge waveguide currents. Finally, the performance of conventional tapered lasers employing a beamspoiler was assessed. The beam quality was found to be comparable with that achieved in the DBR tapered lasers.
1 Photonic and Radio Frequency Engineering Group (PRFEG), Electrical Systems and Optics Research Division, Faculty of Engineering, University of Nottingham, University Park, Nottingham, NG7 2RD, UK
2 Ferdinand-Braun-Institut, Leibniz-Institut für Höchstfrequenztechnik, Gustav-Kirchhoff-Straße 4, 12489 Berlin, Germany